The value of Rfilter is 100 ohms, 0.1% tolerance, for each resistor <- while this value is 10x the recommended value, I suspect it does not have a great impact on our operation, your feedback would be ...

I am calculating the power consumption of all components on my circuit for thermal simulation. The circuit is the same as typical application circuit in the datasheet below and all FETs are ...

Yes, we can transfer the data like indicated but not sure this is the most optimal option. Can you please explain what you are trying to do? On the camera side what serializer are you going to use?

I am asking this for our customer. F280013x is in I2C target. In some cases, F280013x may have sent a byte by writing the byte onto I2CDXR but gets STOP from the controller, so the byte is in I2CXSR ...

Hi，I am using the bq40z50-r2 chip for 2S1P battery packs. I now want the battery pack to be able to actively turn on the discharge MOS when plugged into the power supply device, and then automatically ...

Can the IN+ and IN- of the INA180-Q1 current sensing operational amplifier meet the 5B pulse requirements? (Note: The front-end circuit will have a TVS tube, clamp voltage: 38.9V) ...

We used AWR2243P to realize chip cascade before, but now we can only buy AWR2243 from TI Mall and authorized distributors. It is clearly stated on TI official website and the product description of ...

I encountered a problem when debugging the HRPWM. The EPWMCLK is 100MHz，I think the MEP_ScaleFactor should be 65 or 66 cause the MEP step size is 150ps. But when I use the SFO function, the ...

I am working with the TIDEP-01032 example from the AM243x Motor Control SDK 09.02.00 and don't understand how the EtherCAT Firmware is loaded onto the PRU-ICSSG. In the EtherCAT Slave Simple Demo, ...

28335 tx to RS232 converter tx to (connected DB9 connecter) to DB9 connecter tx to DB9 connecter rx to RS232 rx to TMS320F28069 rx 28335 rx to RS232 converter rx to ...

I want to use interconnect studio. I have read the User'sGuide.However,I was unable to access 「interconnect_studio.itg.ti.com.」 ...

TPS61165DRVRG4 is constant current LED driver. The LCD module backlight has a spec for both voltage and current. for example, our backlight has a current spec 180mA and voltage spec typ 9.6V, max10.2V ...